Reason and treating method why the bearing of the motor is overheated:
1,It is too few and having impurity or oil ring to block to slip lubricating oil of bearing.
Treating method: Should cheer, renewal oil on, repair or change the oil ring. Bearing enterprises navigate
2,There are too little, too much or have iron filling,etc. impurity rolling bearing lubricating greases.
Treating method: The capacity of bearing lubricating grease should not exceed 70% of the total volume, the person who has impurity should be changed. Type inquiry of the bearing
3,High strung or too loose that the axle cooperates with bearing.
Treating method: Should be rubed and pared again at the time of high strung, should inlay one for the pivot when being too loose.
4,Bearing and end overlay and cooperate with high strung or too loose.
Treating method: Process the bearing room at the time of high strung, inlay the steel one in the end is covered when being too loose.
5,Motor both ends are covered or the bearing is covered and assembled badly.
Treating method: Carry, build or bearing build stop mouth put into, install flat, tighten the screw. Bearing world
6,The high strung of the belt or shaft coupling is assembled badly.
Treating method: Adjust the belt tension, correct the shaft coupling.
7,The bearing is damaged.
Treating method: Should change.
