preload preload preload preload

Maintenance of INA bearing on the water pump


8th November 2013 Bearing Technology 0 Comments

Much maintenance of INA bearing is the same, but each kind of trade is different, it has different maintenance. I recommend playing the maintenance of INA bearing on the water pump with everybody today.

1 The water pump coming into operation newly, generally must change lubricating grease oil after operating 100 hours ,Run and change once every 500 hours each time later.

2Adopt the floating INA bearing that lubricating grease lubricates, after running for 1500 hours, should change lubricating grease, there can’t be too much or too little oil quantity with note, because there is too muchly or too little lubricating grease will cause INA bearing to generate heat, the fuel quantity is generally known in 1/2- 2/3 of the volume of bearing room INA.

3For adopting INA bearing that the lubricating oil lubricates, the oil amount should be added to and stipulated the position.

4The container which holds the lubricating oil or lubricating grease should be clean, should seal at ordinary times, there should not be incidentals such as dust, iron filling,etc., so as not to damage INA bearing.

5The motor INA bearing generally adopts sodium base lubricating grease, the characteristic of this kind of lubricating grease is the high temperature of an ability 125 ℃ ,It is but apt it dissolve at water,so can’t pairs of it lubrications used for water pump INA bearing










  • Leave a Reply

    * Required
    ** Your Email is never shared