preload preload preload preload

Maintain the water pump bearing method


31st May 2011 Bearing Technology 0 Comments

Maintain the water pump bearing method:

1,The water pump coming into operation newly, generally must change the grease oil after operating 100 hours ,Run and change once every 500 hours each time later.

2,Adopt the floating bearing that the grease lubricates, after running for 1500 hours, should change the grease, there can’t be too much or too little oil content with note, because there is too muchly or too little grease will cause the bearing to generate heat, the fuel quantity is generally known in 1/2- 2/3 of the volume of bearing room.

3,For adopting and lubricating the bearing of the oil lubrication, oil content should be added to the prescribed position.

4,The container which holds the lubricating oil or grease should be clean, in conformity with the good sealing at ordinary times, there should not be incidentals such as dust, scale specking,etc., so as not to damage the bearing.

5,The motor bearing generally adopts the sodium based grease, the characteristic of this kind of grease is high-temperature 125 ℃ of ability ,But it is at water since it dissolve,so can’t pairs of it lubrications used for water pump bearing.

The Chinese car bearing network is put in order.










  • Leave a Reply

    * Required
    ** Your Email is never shared