preload preload preload preload

INASL185013 get away sub bearing while being full

23rd September 2015 Bearing products 0 Comments

The sub bearing is the design in order to bear the heavy load to hold the cylinder fully and roll. Under the same width, this kind of bearing keeps a bearing comparing with the traditional strip, have extremely high bearing capacity, the section of radial is small, can save the space, but the rotational speed is relatively low. In order to make the bearing work normally, on condition that operate continuously, the bearing must bear certain minimum load, namely C/P

  • Leave a Reply

    * Required
    ** Your Email is never shared