Import the commonly used heating method main point of the bearing:

The commonly used heating method is as follows, to import the bearing

1,Oil groove heating law:

1 This employs wider traditional heating method, the oil slot pitch bottom 50-70mm place sets up the metal network, it is on net that the bearing locates in, the big bearing should be hoisted out with the hook. Inquire about the system in bearing type of the car
2 The bearing should not be put at the bottom of the trough directly, is heated too high so as not to contact the bearing position part of the bottom of trough, or the filth precipitated at the trough bottom enters the bearing. Inquire about the system in bearing type of the car
3 The attention main point of the oil groove heating law is as follows, should use mineral oil which does not have corrosivity with good hot stability, it had better be a voltage transformer oil, oil and container should all keep clean. Inquire about the system in bearing type of the car
4 The capacity of the oil groove answers and is made by size and oil amount of heating the bearing, if the container is too small, while operating continuously, will drop quickly once putting the bearing oil warmly, the result is not good. Inquire about the system in bearing type of the car

2,The heating law of electric stove:

1 Put the bearing into electric stove of close controlling the temperature automatically and heat, heat it evenly, it is accurate to control the temperature, heat it fast, is suitable for a batch of occasions of heating a lot of bearings. Inquire about the software bearing world in bearing type of the car

3,Electric board heating law:

1 Put the bearing for several minutes on the electric board at a temperature of 100 ℃, this law is the most simple and most convenient, can enable the bearing heated evenly such as turning odd times, and efficiency is high, all kinds of bearing can all use this law. Inquire about the software in bearing type of the car

4,The heating law of electric bulb:

1 Utilize the electric bulb of 50W to heat the bearing, can guarantee about heating temperature at 100 ℃, smaller bearing can be put on the bulb directly, in the toper that bigger bearing can locate in the bulb is covered, toper put on can it defends the intersection of bulb and heat to be lost, enable, heat evenly. Bearing navigation
2 The toper can transpose to cover from head to foot, can adapt to heating the bearing of different size within the range of suring. Bearing navigation
3 If adopt the far infrared bulb, it should be downwards to pay attention to the bulb direction, in case that the infrared ray is unfavorable to people’s eyes. Bearing navigation
4 Import the all right energy-conservation of this kind of bulb of the pump. Bearing navigation
5 Bulb heating law is suitable for being small in quantity and often taking; The occasion to be heated to the bearing, the bulb can also do the illumination to use, in addition does not need any other apparatuses at ordinary times. Bearing navigation

5,The heating law of reaction:

1 Can heat the bearing to the necessary temperature to utilize the reaction heater fast, reliably and cleanly, this occasion especially suitable for the inner circle and cooperate closely, it is only an inner circle because of heating, and outer lane heat little, can so as to being relatively easy to install at axle so, it is apt to pack into a hole too. Bearing information