preload preload preload preload

FAG bearing it’s time notes while using

21st November 2013 Bearing Technology 0 Comments

FAG bearing, to the accurate part on condition that roll, it must go on to use cautiously accordingly, no matter what a high-performance bearing is used, or the result improperlied use, will not get the anticipated high-performance form, and the situation that should notice in using to the bearing has the following aspects.

1,The form that will not allow brute force to be punching carefully conscientiously while using and installing, and does not allow to beat the form of the bearing directly with the hammer, not allowing through the body transmits the pressure to rolling, and the result to this can embody the form in this respect, thus can come oning good demonstrate result in this respect.

2,Keep the clean forms of bearing and surrounding environment, the invisible small dust enters the bearing even if it is the naked eye, also will increase the abrasion of the bearing, vibration and noise. Bearing and its peripheral attachment should keep clean, especially dust and filth, tool and working environment must keep clean.

3,Prevent the corrosion of the bearing, while taking the bearing with hands directly, should fully wash the sweat liquid going on hand, and operate after scribbling with high-quality mineral oil, especially should pay attention to antirusting in rainy season and summer. However, under a certain special operation condition, the bearing can be obtained and relatively longer than the life-span that the tradition calculates, especially in case of light load. These special operation conditions are, act as and roll the surface orbit and roll one The oil film lubricated separates and restrains the surface that the pollutant may cause from destroying effectively. In fact, under the ideal condition, the so-called permanent bearing life-span is possible.

4,Use the installation tool suitable, accurate to try hard to use the specific purpose tool, do one’s utmost to avoid using cloth types and short-staple or something like that.

FAG import bearing after the four behavior of way these can pass come on, finding out such a resulting good, if changing, then have a very great change to the bearing clean way too according to such a situation, thus can come to embody such a result slowly, so there is a form of great transition in the trade.

  • Leave a Reply

    * Required
    ** Your Email is never shared