preload preload preload preload

7316CTA/DFP5 bearing


18th September 2015 Bearing products 0 Comments

The angle of uniline is exposed to the axial load that the ball bearing can only bear a direction, while bearing radial load, will cause additional axial force. And can only limit the axle or outer cover in the axial displacement of a direction. The contact angle that the angle contacts the ball bearing is 40 degrees, so can bear the axial load greatly. Contact horn ball bearing is not separating,inside and outside differ shoulder level of both sides enclosed. For with bearing for load ability,will pair the processing is getting lower relatively on shoulder of one side among them, thus let the bearing put into more steel balls.
It is the master’s radial and axial union load and moment load that pair lists the angle and is exposed to the ball bearing and bear greater radial load, limit the axial displacement of two respects of the axle. Used mainly for restraining one pair of one that listed the angle and contacted in the ball bearing, between the outer laneses in the parts of the axle and two-way axial displacement of outer cover from being tiltable and limited, allow the angle of inclination to depend on internal interval, bearing size, inside design of the bearing and act on strength and moment on the bearing, allow the angle of inclination to guarantee to produce the too high additional stress in the bearing the most largely. If store in the bearing, between the outer lanes in the angle of inclination, will influence the life-span of the bearing, cause the bearing to operate the precision to drop at the same time, the noise of operating increases. Pair lists the angle and contacts the ball bearing and generally adopts nylon to keep the shelf or brass entity keeping the shelf. Pair lists the angle should notice, though the bearing can bear the two-way axial load while contacting the installation of ball bearing, but when one side holds ball gaps, should notice that don’t let the main axial load be passed by the ditch of one side with gap. When the bearing uses should pay attention to, make without put the intersection of ball and side of gap roll one bear main load.
The name of product: The new type of 7316CTA/DFP5 bearing: 7316CTA/DFP5 bearing use: The main shaft of the lathe, high-frequency motor, firing steam turbine, centrifugal separator, small-scale car front wheel, differential mechanism pinion axle; Pair lists the angle and contacts the ball bearing: Oil pump, the intersection of thatch and air-blower, air compressor, all kinds of Luo spray the pump, printing machinery by gear box, fuel. Type: The angle contacts the ball bearing










  • Leave a Reply

    * Required
    ** Your Email is never shared