preload preload preload preload

3313AZTN bearing


31st October 2014 Bearing products 0 Comments

The horn can bear radial load and axial load while exposed to the ball bearinging, can bear pure axial load, can work under higher rotational speed. The angle of uniline is exposed to the axial load that the ball bearing can only bear a direction. While bearing radial load, will cause additional axial force, and can only limit the axle or outer cover in the axial displacement of a direction. If the installation in pairs, make the same end of outer lane of a pair of bearings relative, and the wide end, in the face of the wide end, the narrow end so can already avoid causing additional axial force, and can make the axle or outer cover confine in two directions to axial backlash in the face of the narrow end. The angle is exposed to holding the ball quantity more than ball bearing of major groove of the ball bearing, therefore the maximum in the ball bearing of the load capacity, stiffness is strong too, it is stable to operate. Can utilize the radial backlash of mutual shift control of Internal and external cycle.

The name of product: The new type of 3313A-ZTN bearing: 3313A-ZTN bearing use: The basic shaft of the lathe, high-frequency motor, firing the steam turbine, centrifuge, light car front wheel, differential gear box pinion shaft; The two-bank angle 連絡先 the ball bearing: Oil pump, Roots blower, air compressor, all kinds of speed changer, fuel jet pump, printing machine. Type: The angle 連絡先 the ball bearing










  • Leave a Reply

    * Required
    ** Your Email is never shared